• Modular design for up to five (more on request) sensors of any type (PG 13.5 and/or R 1" thread) 

• Cost effective and simple upgrading/retrofitting through variable modules
• Enhanced measuring and process safety by means of the flow monitor module
• Resistant to electrical interference through a potential equalizer pin
• Simple assembly (pre-mounted on panel)
• Quick response time of the measurement because of low volume capacity
• Calibration at the location of the sensor via a sampling tap

• Multiple housing for up to  four sensors (pH, ORP, conductivity, temperature, fluoride; PG 13.5 thread)

• Simple cleaning of the sensor housing and sensor by means of a removable housing cup
• Cup can be used as container for a calibration solution
• Enhanced measuring- and process safety as housing is resistant to electrical interference due to a potential equalizer pin
• Simple mounting for quick installation
• Quick response time of the measurement because of low volume capacity

Multiple Sensor housing for 

• two sensors (pH, redox, conductivitiy, temperature, fluoride) with thread PG 13.5

plus

• one sensor (chlorine, bromine, chlorine dioxide, ozone) with thread R 1" (25mm)

• Simple cleaning of the sensor housing and sensor by means of a removable housing cup
• Cup can be used as container for a calibration solution
• Enhanced measuring- and process safety as housing is resistant to electrical interference due to a potential equalizer pin
• Simple and quick installation
• Quick response time of the measurement because of low volume capacity

• For up to three electrodes (pH, ORP, conductivity, temperature, fluoride; PG 13.5 internal thread)
• Immersion depths: 3 ft., 6 ft.             (1 m, 2 m)

• Accepts a maximum of three sensors (e.g. pH, redox, temperature) with PG 13.5 internal thread, standard length 4.7" (120 mm) 
• Customer can shorten the immersion lance/cut to length on site
• Enhanced measuring- and process safety as housing is resistant to electrical interference though a potential equalizer pin
• Simple and quick installation
• Various accessories available
• Assembly to a flange possible

• For one sensor (pH, ORP, conductivity, temperature; PG 13.5 internal thread) 
• Immersion depths: 3 ft., 6 ft. (1 m, 2 m)

• To hold one sensor (e.g. pH, redox) with PG 13.5 internal thread, standard length 4.7" (120 mm)
• Customer can shorten the immersion lance/cut to length on site
• Enhanced measuring- and process safety as housing is resistant to electrical interference though a potential equalizer pin
• Simple and quick installation
• Various accessories available 
• Assembly to a flange possible

• For one sensor (pH, ORP,  temperature, conductivity; PG 13.5 thread) 
• Mounting: Screw in
• Material: PP for temperatures up to 176° F (80° C) or stainless steel up to 356°  F (180° C) 
• Thread: R ½" and R ¾"

• Simple assembly in pipes and tanks with enhanced requirements for pressure and temperature

• For one sensor (pH, ORP,  temperature, conductivity; PG 13.5 thread) 
• Mounting: Glue in place
• Material: PVC for temperatures up to 122° F (50° C) 
• 3/4" (DN 20) and 1" (DN 25)

• Simple assembly in pipes and tanks for standard conditions
• 90° and 45° angle for optimal orientation of the sensor

• For one pH or ORP electrode (PG 13.5 thread,                                        length: 4.33"-4.93" (110-125 mm)
• Mounting: Thread in
• Material: PP
• Thread: 3/4"

• Direct and simple assembly in pipes and tanks
• Electrodes can be changed without interrupting the process